Fieldbus power conditioner applies to Foundation Fieldbus and PROFIBUS PA control system and provides power to bus-powered devices. Matched with Fieldbus terminator, it adopts uniform impedance characteristic to reproduce bus signal perfectly.

NCS-BP105 Fieldbus Power Conditioner:

NCS-BT105 Fieldbus Terminator:

1. Bus power supply, suitable for fieldbus conforming to IEC 61158-2 standard

2. Comply with the FF-831 bus power supply test specification

3. Active impedance control method

4. Servo voltage output, meeting the requirements of long distance power supply

The fieldbus junction box is used to connect FF H1 and PROFIBUS PA devices to fiedlbus and has the function of terminal matching. When there is no connection at the end of the bus main line and branch line, it can be used as a terminal matcher.

MCAFD4/8 Active Fieldbus Distributor (Junction Box):

1. Bus power supply, suitable for fieldbus conforming to IEC61158-2 standard

2. LED indicators for bus status

3. Short circuit protection and breakdown equipment isolation

4. No effect of other normal working fieldbus devices when installing or uninstalling

5. Low installation cost, simple electric maintenance, waterproof and dust proof of housing joint

6. No polarity of fieldbus input. Not necessary to consider polarity of fieldbus devices

7. Each MCAFD4/8 can connect max 4/8 devices

NCS-HM105 HART modem Industrial automation instrument is upgrading from traditional 4~20mA analog control signal to industrial fieldbus with digital communication function.

NCS-HM105 HART Modem：

1. Complete HART interface, conform to HART physical layer standard

2. Transformer isolation, no ground connection influence

3. Low power consumption, no need of external power source

4. USB and Serial port

MCAT06 is an active termination resistor for PROFIBUS DP and RS-485 networks. With MCAT06, PROFIBUS and other RS-485 2-wire networks can be disconnected directly at the end of the bus. This ensures secure communication even if the bus devices are connected/disconnected during operation.

MCAT06 PROFIBUS DP Active Termination Resistor:

1. Suitable for PROFIBUS DP and other physical layer RS-485 networks

2. Connect the bus using pluggable double-layer spring terminals or Sub-D connectors

3. Active programming and diagnostic equipment can also be powered by Sub-D connectors

4. Standard DIN rail installation